Grade boundaries for Edexcel International GCSE Mathematics A (4MA1) are published by Pearson after each exam series, as raw marks out of 200: the total of your two 100-mark papers. Foundation (grades 5 to 1) and Higher (grades 9 to 4, with 3 allowed) have separate rows, and the numbers change from series to series. This page explains how to read the official tables, what the "notional component" boundaries mean, why some rows have papers ending in R, and why no fixed percentage is ever enough to be sure of a grade.
We do not reprint boundary numbers here. They differ by series and by paper set, so the only safe source is Pearson's own PDF for the series your child sat. If you would like help planning towards a target grade, our one-to-one 4MA1 coaching works online across India and at home in Gurgaon.
Where Pearson publishes them
Pearson posts boundaries on its grade boundaries page. For each series there are two International GCSE documents:
- "Grade Boundaries – International GCSE (9-1)": the overall subject boundaries, which decide the grade.
- "Notional Component Grade Boundaries – International GCSE (9-1)": a boundary for each paper on its own.
On 18 November 2026 the most recent files on the page were for June 2026, dated 20 August 2026. Pearson's key dates say June 2027 International GCSE results may be released on 19 August 2027.
The key definitions, from Pearson
- A grade boundary is the minimum mark at which a grade can be achieved. If a boundary were 70, then 70 gets that grade and 69 gets the grade below.
- Boundaries are in raw marks for linear qualifications like 4MA1, and only the overall qualification boundaries decide the grade.
- All assessments must be taken in the same series for a linear qualification. The 4MA1 specification also says both papers must be taken in the same series.
- Individual papers are not graded. The notional component boundaries are a guide, not a grade per paper.
How 4MA1 marks become a grade
| Step | Foundation | Higher |
|---|---|---|
| Papers | 1F and 2F, 100 marks each | 1H and 2H, 100 marks each |
| Subject total | out of 200 | out of 200 |
| Grades in the table | 5, 4, 3, 2, 1 | 9, 8, 7, 6, 5, 4, 3 |
| Below the lowest boundary | U | U |
Because each 4MA1 paper is 100 marks and worth 50%, the raw marks simply add up. Pearson's notional document explains that scaling is needed only when a paper's raw mark does not match its share of the qualification; for 4MA1 the two are equal, so 100 + 100 = 200 with no weighting factor.
Calculator note. A calculator is allowed on both 4MA1 papers, so there is no separate non-calculator component; both papers count equally towards the same 200-mark total.
Why there can be two Higher rows: the R papers
In the June 2026 document, 4MA1 Higher appears twice: once for papers 1H and 2H, and once for papers 1HR and 2HR. Foundation also has 1F/2F and 1FR/2FR rows. Each row has its own boundaries, and in June 2026 the two Higher rows were different.
So the first job is to check, on the statement of results or with the exams officer, which set of papers your child sat. Using the wrong row can make a grade look wrong when it is not.
Why boundaries move
Pearson's "Understanding grade boundaries 2026" guide for international qualifications says boundaries move to allow for differences in the difficulty of the papers. They are set using statistical evidence and the judgement of senior examiners, then approved by Pearson, so that a grade shows a similar level of performance from year to year.
In practice: a harder paper usually means lower boundaries, and an easier paper higher ones. A lower boundary does not mean the grade was easier to get.
Worked example 1: adding the papers
A Higher student scores 58 on Paper 1H and 66 on Paper 2H. What mark is compared with the boundary table?
Total = 58 + 66 = 124 out of 200.
That total is compared with the overall Higher row for the papers the student sat. As a percentage it is 62%, but percentages are not what Pearson compares; the raw total is.
Worked example 2: what you need on the second paper
After a mock Paper 1H scored 58, a student wants to know what Paper 2H mark would reach a target. If B is the overall boundary for the target grade, read from Pearson's table for a past series, what is needed?
Paper 2H mark needed = B − 58.
This is a useful planning tool with past tables, but remember that the next series will have its own boundaries. Treat the result as a rough target, not a promise.
Worked example 3: why a lower boundary is not "easier"
A school sets two versions of a 50-mark class test. Version A is harder; most students score 8 marks fewer on it than on Version B. If the teacher wants grades to mean the same thing, what should happen to the pass mark for Version A?
It should be lower than for Version B, by roughly the difference in difficulty, so that students of the same ability get the same grade.
This is a school example, not Pearson's method in detail, but it shows the principle Pearson describes: boundaries move to allow for differences in difficulty.
Worked example 4: notional paper boundaries
A student's Paper 1H mark is above the notional grade 7 boundary for that paper, but the Paper 2H mark is below the notional grade 7 for Paper 2H. Is the final grade 7?
Not necessarily either way. The grade comes from the subject total compared with the overall boundary. The notional paper boundaries only show roughly how each paper went. A strong paper can make up for a weaker one, because only the total is graded.
Mistakes families make with boundaries
- Quoting one series' boundaries as fixed, for example "you need X marks for a 9".
- Using the wrong row, Foundation instead of Higher, or 1H/2H instead of 1HR/2HR.
- Treating notional component boundaries as paper grades.
- Converting to percentages and comparing with a percentage from a website.
- Using unofficial sites that copy or estimate numbers, sometimes from the wrong board.
- Mixing up boards. Cambridge 0580 publishes "grade thresholds" with A* to G grades; they cannot be compared directly with 4MA1's 9 to 1.
When to get help
Consider extra support if:
- your child's mock totals sit close to a boundary they need for sixth form or IB entry;
- they are on Higher but scoring near the bottom of the Higher range, where tier choice matters;
- their marks swing widely between practice papers;
- you are unsure whether the grade on a statement matches the right row.
The Foundation or Higher decision guide is the place to start if tier is the worry.
Self-check
- Out of how many marks are 4MA1 overall boundaries given?
- What grades appear in the Higher row?
- Are individual 4MA1 papers graded?
- A student scores 71 on Paper 1F and 64 on Paper 2F. What total is compared with the Foundation row?
- Why might there be two different Higher rows in one series?
Answers. 1: 200 (two papers of 100). 2: 9 to 4, plus 3; below that is U. 3: No; only the qualification is graded, and notional paper boundaries are a guide. 4: 135. 5: Because different paper sets, such as 1H/2H and 1HR/2HR, have their own boundaries.
Where this leads
To understand the grades themselves, read how the 9–1 grades work. To aim at a grade with a plan, use our 25-week revision timetable, and test yourself with the Foundation practice set with answers or the Higher practice questions, set 2. The Edexcel 4MA1 specification guide explains the papers in full. Families comparing boards can read about Cambridge 0580 grade thresholds, which work differently.
How Maths Bodhi helps
In the free demo, our tutor looks at a recent mock or school paper and shows where the marks were lost, which matters more than any boundary. Tutors are matched to 4MA1 and the right tier, and progress is tracked through written method on full papers. Students in other cities join online 4MA1 lessons.
Home tuition is available in Gurgaon (Gurugram). Students elsewhere in India and abroad learn with us online. You can book a free demo class.
Written and checked by the Maths Bodhi team. Facts checked against official Cambridge International and Pearson sources, November 2026.
Frequently asked questions
- Where can I find Edexcel IGCSE Maths grade boundaries?
- On Pearson's grade boundaries page, which has a PDF of International GCSE (9-1) boundaries and a separate notional component PDF for each series. Use the file for the series your child sat.
- Are Edexcel IGCSE Maths grade boundaries the same every year?
- No. Pearson says boundaries move to allow for differences in paper difficulty. They are set after each series using statistics and senior examiners' judgement.
- What are 4MA1 grade boundaries out of?
- The overall boundaries are raw marks out of 200, because each of the two papers has 100 marks. Foundation and Higher have separate rows.
- What are notional component grade boundaries?
- They are boundaries for each paper on its own, published as a guide. Individual 4MA1 papers are not graded; the grade comes from the total of both papers.
- What do 1HR and 2HR mean in the boundary table?
- They are a separate set of Higher papers listed in their own row with their own boundaries. Check your statement of results or ask the exams officer which set was sat.
- Can I get a grade 2 on 4MA1 Higher?
- No. The Higher tier awards grades 9 to 4, with grade 3 allowed. A total below the grade 3 boundary is unclassified (U).
