This guide is for both AA SL and AI SL students. The two courses share a block of common SL content in Topic 3, Geometry and trigonometry: distance and midpoint in three dimensions, volume and surface area of solids, angles in 3D shapes, right-angled trigonometry, the sine and cosine rules, the area of a triangle, angles of elevation and depression, and bearings. Everything in the worked examples below applies to both courses. Where the courses part ways, the guide says so.
The biggest practical difference is the calculator. AA SL Paper 1 is calculator-free, so you may need exact values such as cos 60° = 1/2. Every AI SL paper requires a GDC. For course-matched help, see our AA SL tutors or our AI SL tutors.
What applies to your course
| Content | AA SL | AI SL |
|---|---|---|
| 3D distance, midpoint, volume and surface area of solids | Yes | Yes |
| Angle between two lines, or a line and a plane, in a 3D shape | Yes | Yes |
| Sine rule, cosine rule, area ½ab sin C | Yes | Yes |
| Angles of elevation and depression, bearings | Yes | Yes |
| Ambiguous case of the sine rule | Yes (listed in the AA syllabus) | Check with your teacher |
| Arc length and sector area | In radians, with the unit circle and identities | In degrees |
| Perpendicular bisectors and Voronoi diagrams | No | Yes |
| Calculator | Paper 1 none; Paper 2 GDC | GDC on both papers |
Topic 3 carries 25 of the 150 AA SL teaching hours and 18 of the 150 AI SL hours in the IB guides. AA SL goes on to the unit circle, identities and trig equations, which our AA trigonometry guide covering the unit circle, identities and equations handles. AI SL goes on to Voronoi diagrams.
The toolkit
- 3D distance between (x₁, y₁, z₁) and (x₂, y₂, z₂): √((x₂ − x₁)² + (y₂ − y₁)² + (z₂ − z₁)²). The midpoint averages each coordinate.
- Solids: pyramid V = ⅓ × base area × height; cone V = ⅓πr²h, curved surface πrl; sphere V = ⁴⁄₃πr³, surface 4πr².
- Sine rule: a/sin A = b/sin B = c/sin C. Use it when you know a side and its opposite angle.
- Cosine rule: a² = b² + c² − 2bc cos A, or cos A = (b² + c² − a²)/(2bc). Use it with two sides and the included angle, or with three sides.
- Area of a triangle: ½ab sin C.
- Bearings: measured clockwise from north, written with three figures (050°). The back bearing differs by 180°.
Worked example 1: angles and surface area in a pyramid
A right pyramid has a square base of side 6 cm and a vertical height of 4 cm. Find (a) the length of a sloping edge, (b) the angle between a sloping edge and the base, (c) the volume, and (d) the total surface area.
Let the base centre be M and the apex V. The distance from M to a corner is half the diagonal: ½√(6² + 6²) = 3√2 ≈ 4.24 cm.
(a) Edge = √((3√2)² + 4²) = √(18 + 16) = √34 ≈ 5.83 cm.
(b) The angle sits in the right-angled triangle formed by V, M and a corner: tan θ = 4/(3√2), so θ = 43.3°. The key step is choosing the right triangle: the projection of the edge onto the base runs from the corner to M.
(c) V = ⅓ × 36 × 4 = 48 cm³.
(d) Each triangular face has slant height √(4² + 3²) = 5 cm, from V to the midpoint of a base edge. Each face is ½ × 6 × 5 = 15 cm², so the total surface area is 4 × 15 + 36 = 96 cm².
Notice that the slant height (5) and the sloping edge (√34) are different lengths. Mixing them up is the most common error in this kind of question.
Worked example 2: distance and midpoint in 3D
A(1, −2, 3) and B(4, 2, 15). Find AB and the midpoint of AB.
AB = √(3² + 4² + 12²) = √(9 + 16 + 144) = √169 = 13.
Midpoint = ((1 + 4)/2, (−2 + 2)/2, (3 + 15)/2) = (2.5, 0, 9).
Short, but it appears often as the first part of a longer question, and in AA SL Paper 1 the numbers are chosen to give an exact root.
Worked example 3: bearings with the cosine and sine rules
A boat sails 12 km from port P on a bearing of 050° to A, then 9 km on a bearing of 160° to B. Find (a) the distance PB, (b) the bearing of B from P, and (c) the area of triangle PAB.
Find angle PAB. The bearing of P from A is 050° + 180° = 230°. The boat leaves A on 160°. So angle PAB = 230° − 160° = 70°. Draw north lines at P and at A; this angle is where most marks are lost.
(a) Cosine rule: PB² = 12² + 9² − 2 × 12 × 9 × cos 70° = 151.1..., so PB = 12.3 km (3 s.f.).
(b) Sine rule for angle APB: sin(APB) = 9 sin 70°/12.293..., so angle APB = 43.5°. The bearing of B from P is 050° + 43.5° = 093.5°.
(c) Area = ½ × 12 × 9 × sin 70° = 50.7 km².
Check: the angle at B is 180° − 70° − 43.5° = 66.5°. The largest angle (70°) is opposite the longest side (12.3 km), which is a quick sense check. A coordinate check gives the same distance and bearing.
Worked example 4: two angles of elevation
From point A, the angle of elevation of the top of a tower is 32°. After walking 40 m directly towards the tower to B, the angle of elevation is 51°. Find the height of the tower.
Let T be the top of the tower. In triangle ABT:
- angle at A = 32°
- angle ABT = 180° − 51° = 129°
- angle ATB = 180° − 32° − 129° = 19° (also 51° − 32°)
Sine rule: AT = 40 sin 129°/sin 19° = 95.5 m.
Height = AT × sin 32° = 50.6 m (3 s.f.).
A neat diagram with the 40 m side, both angles and the right angle at the foot of the tower makes this a two-line calculation.
AA only: the ambiguous case
When you use the sine rule to find an angle, sin B = k can have two solutions between 0° and 180°: B and 180° − B.
In triangle ABC, a = 7, b = 9 and A = 40°. Find B.
sin B = 9 sin 40°/7 = 0.826..., so B = 55.7° or B = 180° − 55.7° = 124.3°.
Both are valid, because 40° + 124.3° is still less than 180°. So there are two possible triangles, with C = 84.3° or C = 15.7°. Always test the second angle; if it makes the angle sum exceed 180°, reject it with a sentence.
Mistakes our tutors see
- Bearings measured anticlockwise or from east. Bearings start at north and go clockwise.
- No north line at the second point, so the angle inside the triangle is wrong.
- Slant height and sloping edge confused in pyramids and cones.
- Choosing the wrong right-angled triangle for a line-plane angle in 3D.
- Calculator in radians for a degrees question. Check the mode before Paper 2.
- Rounding PB to 12.3 too early and then getting the sine rule angle slightly wrong.
- Using the sine rule when you have no side-angle pair. Start with the cosine rule instead.
Exam technique
- AA SL Paper 1: expect triangles built on exact values (30°, 45°, 60°) and answers in surd form, such as √34.
- AA SL Paper 2 and all AI SL papers: answers to 3 significant figures, with full values stored. In AI SL, many questions are set in context (surveying, navigation, buildings), so units and a final sentence matter.
- Draw and label first. A labelled diagram with given values circled shows which rule fits.
- Write the rule with numbers substituted before giving the result, so method marks are visible.
Self-check
- Find the distance between (0, 3, −1) and (2, −3, 2).
- A cone has radius 3 cm and height 4 cm. Find its volume and curved surface area.
- B is on a bearing of 070° from A. Find the bearing of A from B.
- A triangle has sides 5, 7 and 8. Find the angle opposite the side of length 7.
Answers. 1: √(4 + 36 + 9) = 7. 2: V = 12π ≈ 37.7 cm³; slant height 5, so curved surface area = 15π ≈ 47.1 cm². 3: 250°. 4: cos θ = (25 + 64 − 49)/80 = 1/2, so θ = 60°.
Where this leads
For AA students, triangle trigonometry leads into the circular functions, and for both courses the 3D work leads to vectors at HL; see our guide to vectors at HL. To see Topic 3 in the context of each full course, read the AA SL syllabus by topic or the AI SL topic list.
How Maths Bodhi helps
Geometry questions are often lost at the diagram, before any trigonometry. In the free demo, our tutor asks the student to draw and label one bearings question and one 3D question, and the diagram shows where the gap is. Tutors are matched to AA or AI, so the practice fits the calculator rules of your papers. See our trigonometry tutoring for how sessions build from triangles to exam questions.
Home tuition is available in Gurgaon (Gurugram). Students elsewhere in India and abroad learn with us online. You can book a free demo class.
Written and checked by the Maths Bodhi team. Facts checked against official IB sources, November 2026.
Frequently asked questions
- Are bearings in IB Maths AA SL and AI SL?
- Yes. Bearings, angles of elevation and depression, and the sine and cosine rules are part of the common SL content that both AA SL and AI SL share.
- How do I find a bearing in an IB maths question?
- Measure clockwise from north and give three figures, such as 093.5°. Draw a north line at every point you work from, and use back bearings (add or subtract 180°) to find angles inside the triangle.
- When should I use the sine rule and when the cosine rule?
- Use the sine rule when you know a side and the angle opposite it. Use the cosine rule when you know two sides and the angle between them, or all three sides.
- Is the ambiguous case of the sine rule in AI SL?
- It is listed in the AA syllabus. If you take AI SL, ask your teacher whether your course expects it, and still check whether a second angle is possible when the diagram is not drawn to scale.
- What 3D geometry is in IB maths SL?
- Distance and midpoint between points in 3D, volume and surface area of solids such as pyramids, cones and spheres, and the angle between two lines or between a line and a plane.
- Can I use a calculator for geometry and trigonometry questions?
- AI SL students use a GDC on every paper. AA SL students cannot use one in Paper 1, so they need exact values such as sin 30° = 1/2, but they use the GDC in Paper 2.
