WhatsApp us
IGCSE Maths18 Nov 2026

IGCSE Histograms and Frequency Density: Drawing, Reading and Unequal Class Widths (0580 E9.7)

Histograms for Cambridge IGCSE 0580 Extended (E9.7): frequency density = frequency ÷ class width, why the area of a bar shows the frequency, how to draw bars for unequal classes, recover frequencies from a histogram, and estimate counts within part of a class.

IGCSE Histograms and Frequency Density: Drawing, Reading and Unequal Class Widths (0580 E9.7)

In an IGCSE histogram, the height of each bar is the frequency density, and frequency density = frequency ÷ class width. That one formula, written into the 0580 syllabus, is the whole topic: because height × width = frequency, the area of each bar shows how many values are in that class. Histograms are sub-topic E9.7 in Cambridge IGCSE Mathematics 0580 and are Extended content only.

Unequal class widths are what make histograms different from bar charts. A wide class with a modest frequency can have a shorter bar than a narrow class with a smaller frequency. Students who plot frequency on the vertical axis get a picture that looks reasonable and earns very little. For where histograms sit among the seven statistics sub-topics, see our guide to the 0580 Statistics strand.

The syllabus in two lines

E9.7 asks you to draw and interpret histograms and to calculate with frequency density. Its notes say the vertical axis is labelled "Frequency density" and define frequency density as frequency ÷ class width. There is nothing else to memorise, but every question tests whether you use that definition in both directions. Students who want an IGCSE 0580 tutor matched to Extended work these in both directions until it is automatic.

Histogram or bar chart?

Bar chartHistogram
DataCategories or discrete valuesContinuous data in classes
Vertical axisFrequencyFrequency density
Gaps between barsUsually, for categoriesNo; bars touch at class boundaries
Bar widthsAll equalEqual to the class widths, which may differ
What shows the frequencyHeightArea

Worked example 1: drawing from a table

The heights, h cm, of 100 seedlings are shown. Calculate the frequency densities and describe the histogram.

Height (h cm)FrequencyClass widthFrequency density
0 < h ≤ 510510 ÷ 5 = 2
5 < h ≤ 102054
10 < h ≤ 2035103.5
20 < h ≤ 3025102.5
30 < h ≤ 5010200.5

Drawing. Height across from 0 to 50 with an even scale, frequency density up from 0 to 4. Each bar runs from its lower to its upper class boundary with no gaps: 0 to 5 at height 2, 5 to 10 at height 4, 10 to 20 at height 3.5, and so on. Label the vertical axis "Frequency density".

What the picture says. The 10 < h ≤ 20 class has the most seedlings (35), but its bar is shorter than the 5 < h ≤ 10 bar. That is correct: 35 seedlings spread over 10 cm are less densely packed than 20 seedlings in 5 cm. The tallest bar shows where the data is most concentrated, not which class has the largest frequency.

Check. Areas: 5 × 2 + 5 × 4 + 10 × 3.5 + 10 × 2.5 + 20 × 0.5 = 10 + 20 + 35 + 25 + 10 = 100. The total area equals the total frequency.

Worked example 2: reading frequencies from a histogram

A histogram of the masses, m grams, of some apples has these bars. Find the number of apples in each class and the total.

ClassBar height (frequency density)
0 < m ≤ 200.8
20 < m ≤ 302.4
30 < m ≤ 355.2
35 < m ≤ 501.2

Rearrange the definition: frequency = frequency density × class width.

  • 0 < m ≤ 20: 0.8 × 20 = 16
  • 20 < m ≤ 30: 2.4 × 10 = 24
  • 30 < m ≤ 35: 5.2 × 5 = 26
  • 35 < m ≤ 50: 1.2 × 15 = 18

Total = 16 + 24 + 26 + 18 = 84 apples.

On a real histogram the hard part is reading the heights accurately from the grid. Check how many units one small square is worth before reading any bar.

Worked example 3: when the vertical axis has no numbers

A histogram has no scale on its vertical axis. The bar for 0 < t ≤ 10 is 3 cm tall and represents 24 people. The bar for 10 < t ≤ 15 is 7 cm tall. How many people does it represent?

Work with areas, measured in "grid units" of width (minutes) × height (cm).

  • First bar: 10 × 3 = 30 units for 24 people, so each unit is 24 ÷ 30 = 0.8 people.
  • Second bar: 5 × 7 = 35 units, so 35 × 0.8 = 28 people.

This style of question checks that you really know area means frequency. Comparing heights alone (7 is more than twice 3) would give the wrong answer, because the second bar is half as wide.

Worked example 4: part of a class, and an estimated mean

Using the seedling data from Example 1, (a) estimate how many seedlings are between 25 cm and 40 cm tall, and (b) estimate the mean height.

(a) Assume values are spread evenly within each class.

  • 25 < h ≤ 30 is half of the 20 < h ≤ 30 class: ½ × 25 = 12.5
  • 30 < h ≤ 40 is half of the 30 < h ≤ 50 class: ½ × 10 = 5

Estimate = 12.5 + 5 = 17.5, so about 18 seedlings. On the histogram this is the area under the bars between 25 and 40: 5 × 2.5 + 10 × 0.5 = 17.5, the same thing.

(b) Midpoints 2.5, 7.5, 15, 25 and 40. Sum of midpoint × frequency = 25 + 150 + 525 + 625 + 400 = 1725. Estimated mean = 1725 ÷ 100 = 17.25 cm.

Histogram questions often end with an estimated mean, so the grouped-data skills in our guide to averages from grouped tables are worth having in place first.

Non-calculator and calculator papers

  • Paper 2 (no calculator): frequency densities are chosen to come out as whole numbers or simple decimals (3.5, 0.8). Division by 5, 10 or 20 is the main skill. Keep a column for class width in your working so each division is visible.
  • Paper 4 (calculator): widths such as 15 or 25 and frequencies that do not divide neatly give densities like 1.47. Give them to 3 significant figures, but plot to the accuracy the grid allows.

The drawing is the same on both papers: ruled bars, touching, on an even horizontal scale.

Mistakes our tutors see

  1. Plotting frequency on the vertical axis instead of frequency density.
  2. Leaving gaps between bars, or using equal widths for unequal classes.
  3. Reading a class width wrongly, for example taking 30 < h ≤ 50 as 10 wide.
  4. Labelling the vertical axis "frequency" or leaving it blank.
  5. Saying the tallest bar has the largest frequency.
  6. In part-class questions, taking half the frequency density instead of half the frequency.
  7. Forgetting that part-class answers are estimates based on an even spread.

When to get help

  • You get the densities right but cannot recover a frequency from a bar.
  • Unlabelled-axis questions leave you stuck at the start.
  • You are unsure whether a question wants frequency or frequency density.
  • Part-of-a-class estimates come out much too large or too small.

Self-check

  1. A class 10 < x ≤ 16 has frequency 18. Find its frequency density.
  2. A bar runs from 20 to 32 with height 3. What frequency does it show?
  3. Find the frequency density for 0 < t ≤ 15 with frequency 45.
  4. A bar of width 8 has frequency density 2.5. Find the frequency.
  5. True or false: the tallest bar in a histogram always has the largest frequency.

Answers. 1: 18 ÷ 6 = 3. 2: 12 × 3 = 36. 3: 45 ÷ 15 = 3. 4: 8 × 2.5 = 20. 5: False. In Example 1, the 10 < h ≤ 20 class has the largest frequency (35) but not the tallest bar.

Where it leads

Histograms and cumulative frequency are often set on the same data, so pair this page with our step-by-step cumulative frequency guide. For paired rather than grouped data, see the scatter graph and correlation guide. Beyond IGCSE, "Representation of data" is the first topic of Probability & Statistics 1 in Cambridge 9709 and continues into the IB Diploma's statistics topic; our IB Maths AI HL tutors work with students who take that route.

How Maths Bodhi helps

The free demo usually includes one histogram question in each direction, table to bars and bars to frequencies. It shows quickly whether the issue is the definition, class widths or reading the grid. After that, practice is set at the right calculator rules for Paper 2 and Paper 4, with progress kept in the student's written work. See how IGCSE maths at Maths Bodhi is organised by syllabus code.

Home tuition is available in Gurgaon (Gurugram). Students elsewhere in India and abroad learn with us online. You can book a free demo class.

Written and checked by the Maths Bodhi team. Facts checked against official Cambridge International and Pearson sources, November 2026.

Frequently asked questions

What is frequency density in IGCSE maths?
Frequency density = frequency ÷ class width. It is the height of each bar on a histogram, and the 0580 syllabus says the vertical axis is labelled "Frequency density".
Are histograms in IGCSE Core maths?
No. In 0580, histograms (E9.7) are Extended content only, so they appear on Papers 2 and 4, not on the Core papers.
How do you find the frequency from a histogram?
Multiply the frequency density (the bar height) by the class width. The area of the bar is the frequency.
Do histogram bars have gaps?
No. The bars touch, because the data is continuous and each bar runs from one class boundary to the next.
How do you draw a histogram with unequal class widths?
Work out frequency ÷ class width for each class, use those values as the bar heights, and make each bar as wide as its class on an even horizontal scale.
How do you estimate how many values fall in part of a class?
Assume the values are spread evenly. Take the fraction of the class width you need and multiply it by that class's frequency, or find the area of that part of the bar.
IGCSE histogramsfrequency densityunequal class widths0580 E9.7 ExtendedIGCSE maths tutor

Related guides

Keep exploring this maths topic

IGCSE Maths18 Nov 2026

IGCSE Statistics Questions: 11 Practice Questions on Averages, Grouped Data, Cumulative Frequency and Histograms

Eleven original IGCSE 0580 statistics questions in two parts: averages, spread and grouped data, then pie charts, cumulative frequency, histograms, scatter diagrams and comparing distributions, each with working and credit notes.

IGCSE statistics practiceIGCSE histogram questionsIGCSE cumulative frequency questions0580 statistics

By Maths Bodhi Team

Read guide

IGCSE Maths18 Nov 2026

IGCSE Maths Statistics Topics (0580 E9): All Seven Sub-topics, Core vs Extended, and How They Are Examined

A map of the Statistics strand in Cambridge IGCSE Mathematics 0580: the seven E9 sub-topics with their Core and Extended status, what each one asks you to do, how statistics appears on the non-calculator and calculator papers, and a study order.

IGCSE statistics0580 E9 statisticscumulative frequency and histogramsCore vs Extended statistics

By Maths Bodhi Team

Read guide

IGCSE Maths18 Nov 2026

IGCSE Mean from a Grouped Frequency Table, plus Median, Mode, Quartiles and IQR (0580 E9.1–E9.3)

How to estimate the mean from a grouped frequency table in IGCSE 0580, with the median, mode, range, quartiles and interquartile range for ungrouped data, which skills are Core and which are Extended, four worked examples and a self-check.

IGCSE grouped frequency meanIGCSE averagesquartiles and interquartile range0580 E9.3

By Maths Bodhi Team

Read guide

IGCSE Maths18 Nov 2026

IGCSE Cumulative Frequency: Tables, Curves, Median, Quartiles, IQR and Percentiles (0580 E9.6)

Cumulative frequency for Cambridge IGCSE 0580 Extended (E9.6): building the running-total table, plotting at upper class boundaries, drawing the smooth curve, and reading the median, quartiles, interquartile range and percentiles, with four worked examples and a self-check.

IGCSE cumulative frequencyquartiles from a graphinterquartile range IGCSE0580 E9.6 Extended

By Maths Bodhi Team

Read guide

IGCSE Maths18 Nov 2026

IGCSE Statistics Charts: Pie Charts, Bar Charts, Pictograms and Stem-and-Leaf Diagrams (0580 E9.4)

Every chart in Cambridge IGCSE 0580 topic E9.4, the same list for Core and Extended: pie charts, composite and dual bar charts, pictograms, stem-and-leaf diagrams and frequency distributions, with four worked examples, the drawing rules examiners look for, and a self-check.

IGCSE pie chartsstem-and-leaf diagramscomposite bar charts0580 E9.4

By Maths Bodhi Team

Read guide

IGCSE Maths18 Nov 2026

IGCSE Scatter Diagrams and Correlation: Plotting, Describing and Using a Line of Best Fit (0580 E9.5)

Scatter diagrams for Cambridge IGCSE 0580 (E9.5, Core and Extended): how to plot points, describe positive, negative and zero correlation, draw a ruled line of best fit by eye using the mean point, make estimates and explain when they are unreliable.

IGCSE scatter diagramscorrelation IGCSEline of best fit by eye0580 E9.5

By Maths Bodhi Team

Read guide