WhatsApp us
IGCSE Maths18 Nov 2026

IGCSE Upper and Lower Bounds: Limits of Accuracy for Core and Extended (0580 E1.10)

How to write the upper and lower bounds of a rounded value, and (for Extended) how to find the bounds of areas, speeds, differences and other calculations in Cambridge IGCSE 0580, with a rule table, four worked examples and a self-check.

IGCSE Upper and Lower Bounds: Limits of Accuracy for Core and Extended (0580 E1.10)

The upper and lower bounds of a rounded value are half a unit either side of it. If a length is 8.4 cm correct to 1 decimal place, the unit of rounding is 0.1 cm, so the lower bound is 8.35 cm and the upper bound is 8.45 cm, written 8.35 ≤ length < 8.45. That is all Core students need. Extended students then use these bounds to find the largest and smallest possible results of a calculation.

This is E1.10 Limits of accuracy in Cambridge 0580. Bounds questions are short, but the Extended ones reward clear thinking about which bound goes where, and many students guess. If your child is one of them, Cambridge IGCSE maths lessons built around the rule table below usually settle it.

Core and Extended

Core (C1.10)Extended (E1.10)
Bounds of a value rounded to a given accuracyYesYes
Bounds of the result of a calculation using rounded dataNot expectedYes

The Core syllabus states that candidates are not expected to find the bounds of results of calculations. The Extended syllabus gives examples such as the upper bound of the perimeter or area of a rectangle measured to the nearest centimetre, and the lower bound of a speed from rounded distance and time. For where this sits in the strand, see our overview of every 0580 Number sub-topic.

The half-unit rule

  1. Find the unit of rounding: nearest 1, nearest 10, 1 decimal place (0.1), nearest 5 and so on.
  2. Halve it.
  3. Subtract it for the lower bound and add it for the upper bound.

The upper bound is written as the exact half-way value, even though a value equal to it would round up. That is why the inequality uses < on the right: 8.35 ≤ x < 8.45. Writing 8.449 or 8.4499… is not the expected form.

Which bound to use in a calculation

This table is the heart of Extended bounds. To make a result as large as possible, you want large numbers on top and in sums, and small numbers in anything you subtract or divide by.

CalculationUpper bound of the resultLower bound of the result
a + bUB of a + UB of bLB of a + LB of b
a − bUB of a − LB of bLB of a − UB of b
a × bUB × UBLB × LB
a ÷ bUB of a ÷ LB of bLB of a ÷ UB of b

The bold entries are the ones students get wrong. Subtraction and division flip the second number.

Worked example 1: bounds of single values

Write down the lower and upper bounds of (a) a length of 8.4 cm, correct to 1 decimal place, (b) a crowd of 2700, correct to the nearest 100, (c) a mass of 60 kg, correct to the nearest 5 kg.

(a) Unit 0.1, half is 0.05: 8.35 ≤ length < 8.45.

(b) Unit 100, half is 50: 2650 ≤ crowd < 2750. In a real crowd the number is a whole number, but bounds questions use the half-unit rule unless they say otherwise.

(c) Unit 5, half is 2.5: 57.5 ≤ mass < 62.5. Students who see "nearest 5" and use ±0.5 lose both marks.

Worked example 2 (Extended): area of a rectangle

A rectangle measures 12 cm by 7 cm, each correct to the nearest centimetre. Find the upper and lower bounds of its area.

Bounds of each side: 11.5 ≤ length < 12.5 and 6.5 ≤ width < 7.5.

Area is a product, so use like with like:

  • Upper bound = 12.5 × 7.5 = 93.75 cm²
  • Lower bound = 11.5 × 6.5 = 74.75 cm²

Give these values in full unless the question asks for rounding. The range is surprisingly wide for a rectangle that "is" 84 cm², which is the point of the topic.

Worked example 3 (Extended): bounds of a speed

A runner covers 250 m, correct to the nearest 10 m, in 31.6 seconds, correct to the nearest 0.1 second. Find the lower bound of the runner's average speed. Give your answer to 3 significant figures.

Bounds of the data:

  • Distance: 245 ≤ d < 255
  • Time: 31.55 ≤ t < 31.65

Speed = distance ÷ time. For the smallest speed, use the smallest distance and the largest time:

Lower bound = 245 ÷ 31.65 = 7.7409… = 7.74 m/s (3 s.f.).

For comparison, the upper bound is 255 ÷ 31.55 = 8.08 m/s. If a question then asks for the speed "to an appropriate degree of accuracy", look for the accuracy at which both bounds round to the same value. Here 7.74 and 8.08 both round to 8 to 1 significant figure, so 8 m/s is the only value you can state with confidence.

Worked example 4 (Extended): a maximum time

A tank holds 1200 litres of water, correct to the nearest 50 litres. It drains at 18 litres per minute, correct to the nearest litre per minute. Find the greatest possible time it takes to empty.

Bounds: 1175 ≤ volume < 1225 and 17.5 ≤ rate < 18.5.

Time = volume ÷ rate. The longest time comes from the most water draining at the slowest rate:

Greatest time = 1225 ÷ 17.5 = 70 minutes.

The shortest time would be 1175 ÷ 18.5 = 63.5 minutes. Questions often hide the operation in words like "greatest possible time", so write the formula first and then decide which bound each part needs.

On the calculator and non-calculator papers

Bounds of single values can appear on any paper, and they need no calculator. Bounds of calculations usually involve decimals like 31.65 that make a calculator welcome, so they appear naturally on Paper 4, but Paper 2 can include simple ones with whole-number answers such as 93.75 or 70. On the calculator paper, keep the unrounded bound values and round only the final result. Our guide to rounding to decimal places and significant figures covers the units of rounding you need to identify first.

Mistakes our tutors see

  1. Using ±0.5 for every question, whatever the unit of rounding.
  2. Writing the upper bound as 8.449. Use 8.45 with a strict inequality.
  3. Using UB ÷ UB for the maximum of a division. The divisor needs its lower bound.
  4. Using UB − UB for the maximum difference. Subtract the lower bound of the second value.
  5. Rounding a bound before using it, for example 31.65 → 31.7.
  6. Not reading "correct to the nearest 0.1 second" carefully, and using the wrong unit for one of the two values.

When to get help

Bounds are one of the few Number topics where Extended students regularly leave a question blank. These signs suggest a tutor would help:

  • The student can do single bounds but freezes when a formula is involved.
  • Answers to "maximum" and "minimum" questions are swapped.
  • Bounds questions inside mensuration or speed problems are skipped.
  • The student cannot explain why dividing by a smaller number gives a larger answer.

The fix is usually conceptual: once a student can say "big over small gives the biggest", the table stops being something to memorise.

Self-check

  1. A mass is 250 g, correct to the nearest 10 g. Write down its bounds.
  2. A length is 0.36 m, correct to 2 decimal places. Write down its upper bound.
  3. A rectangle is 3.7 cm by 2.5 cm, each correct to the nearest millimetre. Find the lower bound of its area.
  4. 100 m is measured to the nearest metre and run in 12.3 s, correct to the nearest 0.1 s. Find the upper bound of the speed to 3 s.f.
  5. A rope is 15.0 m long. A piece 3.6 m long is cut off. Both lengths are correct to 1 decimal place. Find the bounds of the length left.

Answers.

  1. 245 ≤ mass < 255.
  2. 0.365 m.
  3. 3.65 × 2.45 = 8.9425 cm².
  4. 100.5 ÷ 12.25 = 8.2040… = 8.20 m/s.
  5. Upper bound = 15.05 − 3.55 = 11.5 m; lower bound = 14.95 − 3.65 = 11.3 m.

Where it leads

Bounds appear again whenever a measured value is used: in mensuration, in speed and density rates, and in proportion problems such as the scale and recipe questions in ratio and proportion methods. Very large or small measurements bring in numbers written as A × 10ⁿ. When you are ready for mixed questions, the bounds and proportion practice set has worked answers. The habit of asking "how accurate is this value?" carries into A level and IB work on errors and approximation.

How Maths Bodhi helps

In the free demo, the tutor asks for the bounds of one rounded value and one calculation, and listens to how the student chooses each bound. That shows straight away whether the half-unit rule or the choice of bound is the problem. Families in the city can arrange IGCSE maths home tuition in Gurugram with tutors matched to 0580 Extended.

Home tuition is available in Gurgaon (Gurugram). Students elsewhere in India and abroad learn with us online. You can book a free demo class.

Written and checked by the Maths Bodhi team. Facts checked against official Cambridge International and Pearson sources, November 2026.

Frequently asked questions

How do you find upper and lower bounds in IGCSE maths?
Find the unit the value was rounded to, halve it, and subtract it for the lower bound and add it for the upper bound. For 8.4 to 1 d.p., the bounds are 8.35 and 8.45.
Are bounds of calculations on IGCSE Core?
No. Core students only find bounds of rounded values. The 0580 syllabus says Core candidates are not expected to find bounds of the results of calculations; that is Extended content.
How do I find the upper bound of a division?
Divide the upper bound of the top value by the lower bound of the bottom value. Dividing by a smaller number gives a larger result.
How do I find the lower bound of a difference?
Subtract the upper bound of the second value from the lower bound of the first value.
Why is the upper bound 8.45 and not 8.449?
Bounds are written as the exact half-way values with a strict inequality, 8.35 ≤ x < 8.45, so 8.45 itself is the upper bound even though it would round up.
How do I give an answer to an appropriate degree of accuracy using bounds?
Work out the upper and lower bounds of the result and find the accuracy at which both round to the same value.
IGCSE upper and lower boundslimits of accuracy IGCSEbounds of calculations0580 Extended numberIGCSE maths tutor

Related guides

Keep exploring this maths topic

IGCSE Maths18 Nov 2026

IGCSE Bounds Questions: 11 Practice Questions on Upper and Lower Bounds, Ratio and Proportion

Eleven original IGCSE 0580 questions on limits of accuracy, bounds in calculations, ratio and direct and inverse proportion, with a bounds rule card, worked answers and marking notes.

IGCSE bounds practiceIGCSE upper and lower bounds questionsIGCSE direct and inverse proportion0580 limits of accuracy

By Maths Bodhi Team

Read guide

IGCSE Maths18 Nov 2026

IGCSE Maths Number Topics (0580 E1): All 18 Sub-topics, Core vs Extended, and a Study Order

Every sub-topic in the Number strand of Cambridge IGCSE Mathematics 0580, from types of number to surds, with its syllabus reference, what Core and Extended students must know, how Number is examined on the four papers, and a study order.

IGCSE maths number topics0580 Number strandIGCSE Core vs ExtendedIGCSE non-calculator number

By Maths Bodhi Team

Read guide

IGCSE Maths18 Nov 2026

IGCSE Extended Calculator Practice: Paper 4 Style Set 2

Ten more original Paper 4 style questions for Cambridge IGCSE 0580 Extended: growth and decay, bounds, similar solids, histograms, bearings, 3D angles and trig equations, with full worked answers.

IGCSE calculator practice0580 Paper 4 set 2IGCSE Extended questionsIGCSE exam practice

By Maths Bodhi Team

Read guide

IGCSE Maths18 Nov 2026

IGCSE Maths Paper 4 Practice: Mixed Calculator Set 1 With Worked Answers

Ten original Paper 4 style questions for Cambridge IGCSE 0580 Extended, from reverse percentages to stationary points, with full worked answers and mark-style notes.

IGCSE Paper 4 practice0580 calculator questionsIGCSE Extended mathsIGCSE worked answers

By Maths Bodhi Team

Read guide

IGCSE Maths18 Nov 2026

IGCSE Speed, Density and Pressure: Rates Questions Explained (0580 E1.12)

Average speed, unit conversions such as km/h to m/s, density, pressure, flow rates, fuel consumption and population density for Cambridge IGCSE 0580, including which formulas you must know and which are given, with four worked examples.

IGCSE speed density pressureaverage speed IGCSEdensity questions 0580IGCSE rates

By Maths Bodhi Team

Read guide

IGCSE Maths18 Nov 2026

4MA1 Higher Practice Set 1: 10 Edexcel IGCSE Exam-Style Questions with Full Answers

Ten original Edexcel International GCSE Higher questions in rising difficulty, from recurring decimals to turning points, each with a full worked answer and mark-style notes in our own words.

4MA1 Higher practiceEdexcel IGCSE practice questionsInternational GCSE maths revisionHigher tier exam questions

By Maths Bodhi Team

Read guide